dell optiplex 3010 cant install intel graphics driver

If you pop your video card into the second x16 slot, your onboard video does not get shut down. Most current Optiplex machines have two x16 slots. Radeons don't have a lot of support for GPU encoding, so I really wanted that HD4000 active and usable, if not driving a monitor.Īfter a bunch of testing and digging through manuals, I found that the motherboard will always disable the onboard video if you jam a video card into the first PCIe x16.

This was not always the case, as the machine arrived with dual ATI Radeon cards. I do video transcoding on my work machine (Optiplex 7010), and the onboard Intel HD4000 GPU rips through h.264 encoding at an impressive rate.

Reassemble the computer and plug the video cable into the video socket on the rear of the new card.This is an older post, but I thought I'd throw some info into the pot for anyone still looking. Place the metal bracket on the side of the graphics card in the gap between the computer case and the motherboard. Line up the notches on the end of the graphics card with the gaps in the expansion socket. Lift up the retention latch, if applicable, or squeeze either end of the retention mechanism and pull it upward with your other hand to remove it from the case. Push the tab securing the retention latch to the case. Locate the retention mechanism that is secured to the back of the case, next to the expansion slots. Touch the case to ground to prevent a static electricity discharge.įind the PCI slots, positioned near the rear of the motherboard. Open the cover and remove the panel from the tabs securing it to the case. Slide the release latch, located near the back of the computer case, while lifting the cover. Shut down the computer, unplug the power cable when the PC turns off and disconnect all peripheral cables and drives. Right-click the existing video driver and click 'Uninstall.' Follow the on-screen directions to remove the driver.

Dell optiplex 3010 cant install intel graphics driver